ADIY

Sensorsbeginneradiy labs

Interfacing IR sensor, buzzer and Arduino Uno.

Learn how to interface an Arduino Uno with an infrared sensor and a piezo buzzer.

By ADIY2 min read

Interfacing IR sensor, buzzer and Arduino Uno

In this tutorial, you will learn how to interface Arduino Uno, an Infrared sensor, and a piezo buzzer.

Working of an IR Sensor.

IR LED is one kind of transmitter that emits IR radiation. This LED has the appearance of a standard LED, and the radiation it emits is not visible to the human eye. An infrared transmitter is used to detect the radiation by infrared receivers. These infrared receivers are available in photodiode form. IR Photodiodes are different from regular photodiodes in that they only detect IR radiation. Different types of infrared receivers exist based on voltage, wavelength, package, and other factors.

When used as an IR transmitter and receiver, the wavelength of the receiver must match that of the transmitter. The transmitter is an infrared LED, and the receiver is an infrared photodiode. The infrared photodiode is activated by the infrared light produced by an infrared LED. The photodiode’s resistance and the change in output voltage are proportional to the amount of infrared light obtained. This is the IR sensor’s fundamental working principle.

Once the infrared transmitter generates emission, when it arrives at the object & some of the emission will reflect toward the infrared receiver. The sensor output can be decided by the IR receiver depending on the intensity of the response.

ADIY IR Sensor details

Required Components.

Connection steps:

1. Connect the components to the breadboard.

2. Connect GND from Arduino to the negative rail of the breadboard.

3. Connect the 5V from the Arduino to the VCC of the sensor.

4. Connect GND from the breadboard to the GND of the IR sensor.

5. Connect pin7 from Arduino to out of the IR sensor.

6. Connect pin8 from Arduino to the positive terminal of the buzzer.

7. Connect the negative terminal of the buzzer to GND.

8. Connect pin9 to the positive terminal of the LED along with a 220 Ohm resistor.

9. Connect the negative terminal of the LED to GND.

Circuit Diagram.

Result:

Test IR Sensor with different materials and see if you can touch the sensor without triggering it.

You can watch the video below for practicals – https://www.youtube.com/watch?v=SLF6g1Ur9uY&t=5s

Products & resources

  • IR Sensor Module

    Infrared Sensors

    IR Sensor Module With Preset – ADIY

    IR Infrared Obstacle Avoidance Sensor Module with preset by ADIY has a pair of infrared transmitting and receiving tubes. When the transmitted light waves are reflected back, the reflected IR waves will be received by…

    ₹33

    Datasheet
  • Active Buzzer Module

    Sound Sensors

    ADIY Active Buzzer Module

    An active buzzer sensor module has a built-in oscillation circuit, thus the sound frequency is fixed. It can generate the sound itself. So, you can simply turn it on and off with a UNO/Nano pin, just like the way of…

    ₹28

    Datasheet

Share